Non Marring Plate Lifting Clamp

Horizontal clamps are made with medium carbon  steel of  high strength. Extra hard material is used wherever required. Individual clamp is proof  tested with 2 times the load  of working load  limit. Non marring plate clamps can be used  to lift all  structural steel plates including stainless  steel, iron, and aluminum without marking or damaging  the  surface.

• Available in capacities of 4,5 & 6 metric tons pair wise.
• Available jaw opening from (0 – 120 )mm for different sizes
• Individual clamp is proof tested with 2 times the load of working load limit.
• Plates ca be lifted without marking or damaging surface.

Dont’s

• DO NOT use on smooth polished surfaces.
• DO NOT use the clamp on plates with surface contamination (dirt, grease, scale, etc…).
• DO NOT use single clamp.

PART NO.	Capacity (ton)	Jaw Opening (mm)	A	B	C	D	E	F	G
HPLNMC-2	1	0-25	310	310	105	80	150	28	20
HPLNMC-4	2	0-45	443	330	130	85	182	30	25
HPLNMC-6	3	0-45	443	330	130	85	182	30	25
HPLNMC-8	4	0-50	490	350	130	87	215	30	25
HPLNMC-10	5	0-50	490	350	130	87	215	30	25
HPLNMC-12	6	0-80	510	370	150	90	225	32	25
HPLNMC-16	8	10-100	520	370	150	90	225	32	25
HPLNMC-20	10	10-100	520	370	150	90	225	32	25